![background image](http://html1.mh-extra.com/html/gardner-denver/electra-screw-edeqhh/electra-screw-edeqhh_operating-and-service-manual_3711578046.webp)
13–8–610 Page 38
SECTION 8
MAINTENANCE SCHEDULE
SERVICE CHECK LIST –
Air Filter – Operating conditions determine frequency
of service. The “CHANGE AIR FILTER” display will
flash to signal that the air filter requires servicing or
changing. See “Air Filter,” Section 6, page 35.
Oil Separator – Operating conditions determine fre-
quency of service. The “CHANGE SEPARATOR” dis-
play will flash to signal that oil separator element re-
quires changing. See “Compressor Oil Separator” in
Section 5, page 32, for further details.
Motor Lubrication – Refer to Section 2, page 12, and
Maintenance Schedule Chart below.
Every 8 Hours Operation
1.
Check the reservoir oil level – add oil if required.
See Section 5, page 38. If oil consumption is high,
refer to “Excessive Oil consumption, page 40.
2.
Observe if the unit loads and unloads properly.
3.
Check discharge pressure and temperature.
4.
Drain the moisture trap in the control system. See
Section 4, page 16.
5.
Check Panel LED’s for advisories.
Every 125 Hours Operation
1.
Check for dirt accumulation on oil/aftercooler core
faces and the cooling fan. If cleaning is required,
clean the exterior fin surfaces of the cores by
blowing compressed air carrying a nonflammable
safety solvent in a direction opposite that of the
cooling fan air flow. This cleaning operation will
keep the exterior cooling surfaces clean and en-
sure effective heat dissipation.
Every 1000 Hours Operation
1.
Change the oil filter element.
Every 4000 Hours Operation
1.
Change the compressor lubricant. UNDER AD-
VERSE CONDITIONS, CHANGE MORE FRE-
QUENTLY (refer to “Oil Change Interval”, page
29). Flush system if required.
Every Year
1.
Check the relief valve for proper operation. See
Section 4, page 17.
MAINTENANCE SCHEDULE (See detail notes above)
Maintenance Action
If
Panel
Every
Every
Every
Every
Every
LED is
8
125
1000
4000*
Year
Lit
Hours
Hours
Hours
Hours
Change Air Filter
D
Change Oil Separator
D
Check Reservoir Oil Level
D
Check For Proper Load/Unload
D
Check Discharge Pressure/Temp
D
Check Dirt Accumulation on Cooler
D
Change Oil Filter Element
D
D
Change Compressor Lubricant (AEON 4000)
D
D
Check Relief Valve
D
*
See Oil Change Interval Chart, FIGURE 5–3, Page 29, for specific lubricant life.
Summary of Contents for ELECTRA-SCREW EDEQHH
