GARDTEC
580
ENGINEERS MANUAL
Page 10
System Programming
The system may be programmed by the engineer by use of the engineer code (1234
factory default). Other functions are also available to the engineer, these are as fol-
lows.
Set
The engineer may fully set the system or partset the system.
Unset
The engineer may only unset the system using the engineer code if it has previously
been set using the engineer code.
Remove
The engineer may remove individual zones when setting the system.
Test
The engineer may use this function to test the system.
Log
Using this function the engineer may read the log. The log will be shown on a last
event first basis.
Chime
Using this function the engineer may turn the chime function on and off. It should be
noted that chime zones must first be programmed from the engineer zone option.
The above options will be dealt with in the section Engineer Modes
Fig 6. shows the flow chart to be used when programming the GARDTEC
580
580 Eng PR2945.QXD 07/03/01 16:19 Page 13
Technical Manuals Online! - http://www.tech-man.com
