AFTER SALES SUPPORT
21
1300 855 831
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
MODEL: HL650o PRODUCT CODE: 63736 04/2019
AUS
Setup/Before starting the equipment/Operation
VI. SETUP
Prepare the workplace where the machine is to be placed.
Ensure sufficient room to allow safe work without malfunctions.
The machine is designed to operate on a level surface and must be placed se-
curely on stable plain ground.
VII. BEFORE STARTING THE EQUIPMENT
Make sure the machine is completely and expertly assembled.
Check before every use:
• The connection cables for any defective spots (cracks, cuts etc.).
• The machine for any possible damage.
•
The firm seat of all bolts.
• The hydraulic system for leakage.
• The oil level.
VENTING, FIG. 7 / 8
m
ATTENTION!
Before working with the log splitter, vent the hydraulic system.
• Release the Venting Screw (12) by a few revolutions so the air can escape from
the oil tank.
• Leave the Venting Screw (12) open during the operation.
• Before you move the log splitter, close the Venting Screw (12) again in order not to
lose any oil.
If the hydraulic system is not vented, the enclosed air will damage the gas-
kets and with it the complete log splitter.
VIII. OPERATION
Only split plain cut logs.
SWITCHING "ON" AND "OFF"
m
ATTENTION!
Loosen the Venting Screw (12) two revolutions, before starting work.
Close before transport. FIG. 7 / 8
1.
Place the splitting material in horizontal direction to the Work Table (3).
2.
Your machine is equipped with Two-hands Control System that requires opera-
tion by both hands of the user
– left hand controls the Hydraulic Lever (10) while
