To clean the trimmer:
w
4
DANGER! Electric shock!
Risk of injury and risk of damage to the unit.
v
Do not clean the unit with water or with a water jet
(in particular high-pressure water jet).
The airflow slots must always be clean.
1. Clean the airflow slots
w
with a soft brush
(do not use a screwdriver).
2. Clean all movable parts after each operation. Especially remove
any grass and dirt from the cover
4
.
To replace the filament
cassette:
DANGER! Risk of physical injury!
Risk of injury from metal cutting parts!
v
Do not use metal cutting parts or replacement parts and
accessories not approved by GARDENA.
r
t
r
e
i
5
u
o
t
z
Only use original GARDENA Filament Cassettes. You can
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
For Art. 9805 SmallCut 300/23 / Art. 9806 SmallCut Plus 350/23:
GARDENA Filament Cassette for Turbotrimmers Art. 5307
1. Push in cassette cover
e
on the two locking clips
r
at the same
time and remove.
2. Remove the filament cassette
t
.
3. Remove all dirt.
4. Pull approximately 15 cm of the cutting filament
5
out of the new
filament cassette
t
through the hole in the plastic ring
z
.
5. First put the cutting filament
5
through the metal sleeve
u
.
6. Put the cutting filament
5
around the guide pin
i
.
7. Put the filament cassette
t
into the filament cassette holder
o
.
8. Attach the cassette cover
e
on the filament cassette holder
o
until you hear both locking clips
r
make a click.
When attaching the cassette cover
e
, the cutting filament
5
must
be put around the guide pin
i
and must not be caught.
v
If the cassette cover
e
cannot be fully installed, turn the filament
cassette
t
back and forth, until the filament cassette
t
is fully in
the filament cassette holder
o
.
7
GB
