Gardena SILENO+, Operator'S Manual

Page: 26 / 56

With the
Lawn Coverage function the product first
follows and then leaves the guide wire after a
certain distance and starts to mow the lawn.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
A
C
B
3.10.7.1 To set the Lawn Coverage function
1. Do steps 1–3 in
To get access to the menu
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Lawn Coverage > Area 1-3.
3. Use the arrow button to select the area.
4. Push the OK button.
5. Measure the distance from the charging
station to the start of the area. Measure
along the guide wire. Refer to
To measure
the distance from the charging station on
page 26.
6. Push the number buttons to select the
distance.
7. Push the OK button.
8. Use the number buttons to select the
percentage of the cutting time the product
must cut the area. The percentage is equal
to the area in relation to the complete work
area.
a) Measure the area.
b) Divide the measured area with the total
work area.
c) Convert the result to percentage.
Note: The sum of Area 1-3 must be 100% or
less. If the sum is less than 100%, the
product sometimes starts to mow at the
charging station. Refer to
To set the exit
angles on page 27.
9. Push the BACK button.
3.10.7.2 To do a test of the Lawn Coverage
function
1. Put the product in the charging station.
2. Do step 1-3 in
To get access to the menu on
page 23.
3. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Lawn Coverage > Area 1-3 > More > Test.
4. Push the OK button.
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
3.10.7.3 To measure the distance from the
charging station
1. Put the product in the charging station.
2. Do steps 1–3 in
To get access to the menu
on page 23.
3. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Lawn Coverage > Area 1-3 > How far?
4. Use the number buttons to set 500 m / 540
yd as a distance.
5. Push the OK button.
6. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1-3 > More > Test.
7. Push the OK button.
8. Push the STOP button when the product is
at the distance you select to measure. The
distance shows in the display.
3.10.7.4 To disable or enable the Lawn Coverage
function
Disable or enable the
Lawn Coverage function for
each area.
1. Do steps 1–3 in
To get access to the menu
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure Installation
> Lawn Coverage > Area 1-3 > Disable.
26 - Installation 1378 - 003 - 16.04.2020