3. Push the OK button.
4. Push the BACK button.
3.10.7.5 To reset the Lawn Coverage settings
You can reset the
Lawn Coverage settings for
each area and use the factory setting.
1. Do steps 1–3 in
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Lawn Coverage > Area 1-3 > More >
Reset.
3. Push the OK button.
3.10.8 Exit angle
If the sum of the
Lawn Coverage function is less
than 100%, the product sometimes starts to mow
at the charging station. The product moves away
from the charging station with an exit angle
between 90°–270°. The exit angles can be set to
1–2 exit sectors.
3.10.8.1 To set the exit angles
1. Do steps 1–3 in
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure
Installation
> Advanced > Exit angles > Sector 1 or
Sector 2.
3. Use the number buttons to set the angles in
degrees.
4. Push the down arrow button.
5. Use the number buttons to select how
frequently the product must use each sector.
Set in percentage.
6. Push the BACK button.
3.10.9 Reversing distance
The reversing distance makes the product move
in reverse for a set distance, before the product
starts to cut the lawn. The factory setting is 60
cm / 24 ft.
3.10.9.1 To set the reversing distance
1. Do steps 1-3 in
on page 23.
2. Use the arrow button and the OK button to
move through the menu structure
Installation
> Advanced > Reversing distance.
3. Use the number buttons to set the distance.
4. Push the BACK button.
3.10.10 Drive Past Wire
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
factory setting for the
Drive Past Wire function
function is 32 cm / 12 in. You can select a
distance of 25-40 cm / 10-16 in.
Note: With the factory setting the product will cut
11 cm / 4.3 in. past the wire.
Note: If the
Drive Past Wire distance is changed,
the distance will change along the boundary wire
everywhere in the work area.
3.10.10.1 To set the Drive Past Wire function
1. Do steps 1–3 in
on page 23.
2. Use the arrow button and the OK button to
move through the menu structure
Installation
> Advanced > Drive Past Wire.
3. Use the number buttons to set the distance.
4. Push the BACK button.
3.10.11 Guide Corridor
The guide corridor is the area adjacent to the
guide wire, which the product uses to find the
charging station. When the product moves in the
direction of the charging station, it always moves
to the left of the guide wire.
Note: The product runs at different distances to
the guide wire but stays within the guide corridor.
1378 - 003 - 16.04.2020
Installation - 27
