Gardena SILENO+, Operator'S Manual, Page: 23 / 56

3. Push the arrow buttons and the OK button.
Select language, country, date, time and set
a PIN code.
Note: For some models, a factory PIN code
is necessary before you select a personal
PIN code. It is not possible to use 0000 as
PIN code.
4. Push the Start button and close the hatch to
initiate a calibration process of the product.
Note: If the battery is too low, the product
needs to charge the batteries fully before the
calibration starts. Refer to Calibration on
page 23.
Note: Make a note of the PIN code. Refer to
Introduction on page 3.
3.9.3 Calibration
The calibration process is automatic. After the
basic settings are done, the product moves away
from the charging station and stops, while it
calibrates some of the product settings. When the
calibration is complete, the product starts to mow.
3.10 To do the product settings
Use the control panel to set all settings for the
product. The control panel has a display and a
keypad, you can access all functions through the
menus. The functions have factory settings that is
applicable for almost all work areas, but the
settings can be adapted to the conditions for
each work area.
3.10.1 Menu structure
The main menu contains:
•
Schedule
•
SensorControl
•
smart system (only for smart )
• Settings
•
Installation
•
Security
Refer to Menu structure overview 1 on page 7
and
Menu structure overview 2 on page 8.
3.10.2 To get access to the menu
1. Push the STOP button.
2. Use the number buttons and the OK button
to enter the PIN code.
3. Push the MENU button.
3.10.3 Schedule
Note: The lawn should not be cut too often to
obtain the best result. If the product is allowed to
operate too much, the lawn may appear
flattened. The product is also subjected to
unnecessary wear.
3.10.3.1 To set the schedule
1. Do steps 1–3 in
To get access to the menu
on page 23.
2. Use the arrow buttons and the OK button to
move through the menu structure Schedule
> Overview.
3. Use the arrow buttons and the OK button to
select the day.
4. Use the right arrow button to select the
period.
5. Push the OK button.
6. Calculate the suitable operating hours. Refer
to To calculate the suitable operating hours
on page 23.
7. Enter the time with the number buttons. The
product can cut the grass 1 or 2 periods
each day.
8. If the product must not cut grass on a
specified day, unselect the box adjacent to
the 2 time periods.
3.10.3.2 To calculate the suitable operating hours
If the work area is less than maximum product
capacity, the schedule should be set to minimize
wear on the lawn and the product.
1. Calculate the dimension of your lawn in m
2
/
ft
2
.
1378 - 003 - 16.04.2020 Installation - 23