Max 3 cm/1.2"
Max 3 cm/1.2"
Max +/- 2 cm / 0.8 in.
•
If the work area has two parts separated with a
steep slope, we recommend to put the charging
station in the lower section.
•
Put the charging station in an area with protection
from the sun.
•
If the charging station is installed on an island,
make sure to connect the guide wire to the island.
To make an island on page 14
.
3.4.2 To examine where to put the power
supply
WARNING:
Do not cut or extend
the low-voltage cable. There is a risk of
electrical shock.
CAUTION:
Make sure that the blades
on the product do not cut the low-voltage
cable.
CAUTION:
Do not put the low-voltage
cable in a coil or below the charging station
plate. The coil causes interference with the
signal from the charging station.
•
Put the power supply in an area with a roof and
protection from the sun and rain.
•
Put the power supply in an area with good airflow.
•
Use a residual-current device (RCD) with a tripping
current of maximum 30 mA when you connect the
power supply to the power outlet.
Low-voltage cables of different lengths are available as
accessories.
3.4.3 To examine where to put the
boundary wire
CAUTION:
There must be a barrier of
minimum 15 cm / 6 in. in height between
the boundary wire and water bodies, slopes,
precipices or public roads. This will prevent
damage to the product.
CAUTION:
Do not let the product
operate on gravel.
CAUTION:
Do not make sharp bends
when you install the boundary wire.
CAUTION:
For careful operation
without noise, isolate all obstacles such as
trees, roots and stones.
The boundary wire should be put as a loop around the
work area. Sensors in the product senses when the
product approaches the boundary wire, and the product
selects another direction. All parts of the work area must
be maximum 15 m / 50 ft. from the boundary wire.
To make the connection easier between the guide wire
and the boundary wire, it is recommended to make an
eyelet where the guide wire will be connected. Make the
12 - Installation
1585 - 007 - 26.10.2022
