17
GB
1. Push a threaded ring
7
over both universal connectors
5
and
6
.
2. Screw the transparent universal
connector
5
with dirt indicator
8
onto the water outlet
9
(see
arrow markings on the cover).
Pay attention to the installation
position of the dirt indicator
8
.
3. Screw the black universal
connector
6
with flat seal
0
onto the water inlet
A
.
4. Push one hose clamp
B
onto the connecting hose
1
and
one on the return hose
C
.
5. Push the connecting hose
1
on the black universal
connector
6
and secure with the hose clamp
B
.
6. Push the return hose
C
onto the transparent universal
connector
5
and secure with the hose clamp
B
.
For safety reasons, the UVC lamp is supplied unassembled.
v
Assembling the lamp in the UVC device: (see
8. Trouble-
Shooting
“ Replacing lamp”
).
5. Initial Operation
If the pressure filter is buried below the surface, the hose
connectors must be located above the surface of the pond.
When using a stream, the maximum height must not be
exceeded.
1. Bury or position the pressure filter
D
securely at least 2 m
away, next to the garden pond and above the surface of the
pond (max. 1 m with PF 10000 or 1.5 m with PF 15000).
2. Place the pump
E
in a stable position within the garden pond
so that the pump
E
is completely covered with water.
3.
Plug the mains plug of the pump
E
into a 230 V AC socket.
Warning : The pump will start immediately !
4. Remove the cover
F
of the UVC device.
5. If the pressure filter
D
is filled with water, connect the power
supply of the UVC device in a 230 V alternating current socket.
The UVC control lamp is lit blue (more visible at dusk / in
darkness).
6. Replace the cover
F
of the UVC device.
Switch off the UVC Pressure Filter Set :
1. First, disconnect the UVC device from the power supply.
2. Then disconnect the pump from the power supply.
PF 10000 = 1 m
PF 15000 = 1,5 m
D
F
E
Connecting the hoses to the
pressure filter :
Assembling the lamp in the
UVC device :
Operating the UVC-Pressure
Filter Set :
8
8
5
7
9
0 6
A
5
C
6
1
B
