Gardena 5600 Silent+, Operator'S Manual

Page: 8 / 14

6.4 Troubleshooting table:
For Art. 9058 / 9059: See additional explanation of the displays in
the Bluetooth
®
Display Operator’s manual.
Problem Possible Cause Remedy
Pump is running,
but the suction action
doesn’t take place
Leaky or damaged suction line
[ Fig. A2 ].
v
Check the suction line
for damage and seal so
is airtight.
Pump sucks in air at a con­
nection point [ Fig. A2 ].
v
Seal the suction side
connections airtight.
No water available in the
cistern, water tank, water
pipe, etc.
v
Make sure that the water
supply is on the suction side.
Pump was not filled with
water [ Fig. A4 ].
v
Fill the pump
(see 3.1.3 Initial operation
of the pump ).
Water escapes during
the suction process via
the pressure hose.
1. Fill the pump again.
2. Hold up the pressure hose.
3. Start the pump again
(see 3.1.3 Initial operation
of the pump ).
Absolutely vacuum­resistant connection is achieved by using
GARDENA Suction Hoses (see
8. ACCESSORIES / SPARE PARTS
).
Screw fitting on the filler neck
is leaking [ Fig. A2 ].
v
Check the seal (replace
if necessary) and tighten
the screw fitting by hand
(do not use pliers).
Air cannot escape, since the
delivery line is closed or
remaining water is in the
pressure hose.
v
Open any shut­off valves
(e. g. nozzle) in the delivery
line, or drain the pressure
hose.
Air cannot escape because
the pressure hose is coiled.
1. Lay out the pressure hose
straight along its entire
length.
2. Lay the hose from the pump
outlet upwards.
3. Do not kink the pressure
hose at the pump outlet.
4. Open all consumers maxi­
mum.
Suction time of 5 min. was
not waited for.
v
Wait up to 5 minutes for the
pump to pump water.
Suction filter or backflow
preventer in the suction hose
are clogged.
v
Clean the suction filter or
the backflow preventer.
The end of the suction hose
is not in the water [ Fig. A5 ].
v
Submerge the end of the
suction hose deeper in the
water.
Suction height is too high
[ Fig. A5 ].
v
Reduce the suction height.
In case of any other difficulties concerning the suction action,
use GARDENA Suction Hoses with Backflow Preventer
(see
8. ACCESSORIES / SPARE PARTS
). Fill the pump with
water before starting it.
Pump does not start,
or stops suddenly during
operation
Thermal switch has turned
the pump off because of over­
heating.
v
Let the pump cool down,
empty the pump and fill it
again.
v
Observe the max. media
Temperature (35 °C).
No power supply to the pump.
v
Check the fuses and electrical
plug connections.
RCD has triggered
(residual current).
v
Unplug the plug from the
mains socket and contact
the GARDENA Service.
Pump is not switched on.
v
Push the On / Off switch to
the position
On
.
Pump is running but the
delivery drops suddenly
The end of the suction hose
is not in the water [ Fig. A5 ].
v
Submerge the end of the
suction hose deeper in the
water.
Suction filter or backflow
preventer in the suction hose
are clogged.
v
Clean the suction filter or
the back flow preventer.
No water available in the
cistern, water tank, water
pipe, etc.
v
Make sure that the water
supply is on the suction side.
Suction line is leaking
[ Fig. A2 ].
v
Eliminate the leak.
Impeller is blocked.
v
Loosen the impeller.
Problem Possible Cause Remedy
Pump is running but the
delivery drops suddenly
Pressure hose is kinked.
v
Lay the pressure hose with­
out kinks and do not kink the
pressure hose at the pump
outlet.
The screw connection
of the filter cannot
be unscrewed by hand
Tread is dirty.
v
Use a water pump pliers to
unscrew it.
v
Clean the thread on the filter
and in the pump.
NOTE:
Repairs must only be done by the GARDENA service departments or
specialist dealers approved by GARDENA.
v
For any other malfunctions please contact the GARDENA service
department.
7. TECHNICAL DATA
Garden pump Unit Value
(Art. 9057)
Value
(Art. 9058)
Value
(Art. 9059)
Rated power W 900 1050 1300
Mains voltage
V (AC) 230 230 230
Mains frequency Hz 50 50 50
Max. delivery capacity l/h 5600 6300 6500
Max. pressure /
Max. delivery head
bar /
m
4.7
47
4.9
49
6.0
60
Max. self-priming suction
height
m 8 8 8
Permitted internal pressure
(delivery side)
bar 6 6 6
Power cable m
1.5
(H07RN­F)
1.5
(H07RN­F)
1.5
(H07RN­F)
Weight without cable
(approx.)
kg 10 10.7 11.8
Sound pressure level L
pA
Distance: 1 m
5 m
10 m
dB
58
45
38
59
45
39
60
46
40
Sound power level L
WA
1)
:
measured / guaranteed
Uncertainty k
WA
dB (A)
67 / 69
2.67
68 / 70
2.29
68 / 71
2.78
Max. media temperature °C 35 35 35
Measuring process complying with: 1)
RL 2000/14/EU
8. ACCESSORIES / SPARE PARTS
GARDENA Suction Hoses Kink­proof and vacuum­proof, optionally available by the metre
Art. 1720 / 1721 (19 mm (3/4") / 25 mm (1") without connecting
fittings or in fixed length Art. 1411 / 1418 complete with connect­
ing fittings.
GARDENA Suction Hose
Fitting
For connection on the suction side.
Art. 1723 / 1724
GARDENA Pump Connection
Set
For connection on the delivery side. Art. 1750 / 1752
GARDENA Suction Filter
with backflow preventer
To equip suction hoses with backflow
preventer sold by the meter.
Art. 1726 / 1727 /
1728
GARDENA Pump Preliminary
Filter
Recommended for pumping sandy water. Art. 1730 / 1731
GARDENA Bore Hole Suction
Hose
For vacuum­resistant connection of the pump
to boreholes or pipe networks. Length 0.5 m.
With 33.3 mm (G1) female thread at both ends.
Art. 1729
GARDENA Floating suction
system
For dirt­free suction below the water surface. Art. 1417
GARDENA Quick coupling For pressure­side connection of 1" pressure
hoses.
Art. 7109 / 7103
GARDENA Soil Moisture
Sensor
For irrigation depending on the soil
moisture.
Art. 1188 / 1867
GARDENA Extension Cable
(length: 10 metres)
Used to extend the sensor cable to
max. 105 metres.
Art. 1868
en
13