12
GB
3. Initial Operation
Hose diameter
Pump connection
13mm (1/2")
GARDENA
Pump Connection Set
Art. 1750
16mm (5/8")
GARDENA Tap Connector
Art. (2)902
GARDENA Hose Connector
Art. (2)916
19mm (3/4")
GARDENA
Pump Connection Set
Art. 1752
The pump connection component
1
is already pre-installed by
the manufacturer together with the check valve
ß
v
.
v
Connect hose via the relevant GARDENA Connection System.
Backflow preventer
ß
v
:
The backflow preventer
ß
v
prevents the hose from running empty
after the pump has been turned off or taken out of operation.
With a parallel connection of more than one hose or connected
devices, the
GARDENA 2- / 4-Way Valve (Art. 8193 / 8194)
can
be used, which is screwed straight onto the pump connection
piece
1
.
1. Attach the fastening rope
3
to the handle
4
.
2. Submerge pump in the fountain or water reservoir via the
fastening rope
3
.
3. Secure fastening rope
3
.
4. With deep fountains or shafts (from approx. 5m), route the
connection cable
5
along the fastening rope
3
with clips.
Thermal protection switch:
In the event of an overload, the pump is switched off by the
built-in thermal motor protection. After sufficient cooling of the
motor, the pump is operational again.
min.
min.
30 cm
3
4
6
5
ß
t
The pump must always be submerged in the fountain or water
reservoir with the fastening rope
3
provided. For the pump
to be primed, the pump must be submerged to the minimum
submersion depth
ß
t
(see 8. Technical specifications).
So that the filter does not become dirty, the pump should be
fixed at least 30cm above the ground.
Pump installation:
1
ß
v
19mm (3/4")- / 16mm (5/8") and 13mm (1/2") hoses can be
connected via the GARDENA Connection System.
Connect hose via the GARDENA
Connection System:
1461-20.960.05 30.06.2011 10:32 Uhr Seite 12
