2. ASSEMBLY
Before you do assembly:
WARNING! Risk of physical injury!
Cut injury when the blade turns or the product starts
accidentally.
v
Wait for the blade to stop, remove the safety key and use
gloves before you do assembly.
WARNING! Risk of explosion!
Protect batteries from heat and fire. Do not leave on
radiators or expose to strong sunshine for long periods.
Do not operate in explosive atmospheres, such as in
the presence of flammable liquids, gases, or dust.
Batteries may create sparks which could ignite the dust
or fumes.
Check your replacement battery before each use. Visually
check the battery before each use. A non-functioning
battery must be disposed of correctly. Do not send by
post. For further details, please contact your local dispos-
al companies.
For risks of injury do not use the battery as a power
source for other products. Only use the battery for the
GARDENA product intended.
Only use and charge the battery in ambient temperatures
of between 0 °C and 40 °C. Allow battery to cool down
after long periods of use.
Check the charging cable regularly for signs of damage
or ageing (brittleness). Only use it in perfect condition.
Do not stow the battery above 45 °C or in direct sunlight.
Ideally, the battery should be stored below 25 °C so that
self-discharge is low.
Do not expose the battery to rain or wet conditions. Water
entering a battery will increase the risk of electric shock.
Keep battery in order (clean) especially air vents.
If usage of the battery is not planned for a certain time
(winter period) reload the battery to avoid a deep dis-
charge.
Do not stow while still attached to a tool, this prevents
misuse and accidents.
Do not stow the battery in places where static electricity is
present.
Electrical safety
WARNING! Cardiac arrest!
This product makes an electromagnetic field while it oper-
ates. This field may under some conditions interfere with
active or passive medical implants. To decrease the risk
of conditions that can possibly injure or kill, we recom-
mend persons with medical implants to speak with their
physician and the medical implant manufacturer before
you operate the product.
Before use, examine the cable for signs of damage or
ageing. If the cable is found to be defective, take the
product to an Authorised Service Centre and have the
cable replaced.
Do not use the product if the electric cables are damaged
or worn.
Immediately disconnect from the mains if the charger
cable is cut, or the insulation is damaged. Do not touch
the electric cable until the cable has been disconnected.
Do not repair a cut or damaged cable. Replace it with
a new one.
Do not carry the product by the cable.
Do not pull on the cable to disconnect any of the plugs.
Use only on AC mains supply voltage shown on the prod-
uct rating label.
Our products are double insulated to EN 60335. Do not
connect an earth to any part of the product.
Check the working area for hidden cables.
Do not use for pond care or close to water.
Personal safety
WARNING! Risk of suffocation!
Small parts can be easily swallowed. There is also a risk
that the polybag can suffocate toddlers. Keep toddlers
away when you assemble the product.
Do not use in explosive atmosphere.
Never operate the product when you are tired, ill or under
the influence of alcohol, drugs or medicine.
Do not overload the mower.
Use gloves, wear slip resistant shoes and wear eye
protection.
Do not use under wet conditions.
Do not disassemble the product further than the delivery
status.
Only start the mower with an upright standed handle.
Do not use the start levers alternately.
Use the handles carefully.
Safety Cut-Out
The engine is protected by a Safety Cut-Out which is acti-
vated when the blade becomes jammed or if the engine is
overloaded. When this occurs, stop and disconnect the
product from the mains. The Safety Cut-Out will only reset
when you release the start/stop lever. Clear any obstruc-
tion and wait for a few minutes for the Safety Cut-Out to
reset before you continue to use the product.
To connect the lower handle:
3
3
2
1
ß
H
ß
M
ß
L
The handle height can be adjusted in 3 positions.
•
ß
H
High.
•
ß
M
Middle.
•
ß
L
Low.
1. Turn the lower handle
(1)
that the handle hole is inline with the
hole
ß
H
,
ß
M
or
ß
L
of the height adjusting.
2. Push the screws
(2)
through the holes.
3. Put the wing nuts
(3)
on the screws
(2)
.
4. Tighten the wing nuts
(3)
.
To connect the upper handle:
(4)
(1)
(2)
(3)
(3)
ß
P
ß
P
1. Put the upper handle
(4)
on the lower handle
(1)
.
Make sure that the handles are fully in place and the handle
holes are inline.
2. Push the screws
(2)
through the holes.
3. Put the plastic washers
ß
P
and the wing nuts
(3)
on the screws
(2)
.
4. Tighten the wing nuts
(3)
.
To fix the cable to the handle:
(6)
(5)
1. Fix the cable
(5)
to the handle with the clip
(6)
.
2. Check that the cable
(5)
is not trapped between the lower and
the upper handle.
To assemble the grass box:
(7)
ß
N
(8)
1. Put the nose
ß
N
of the handle
(7)
into the grass box.
2. Turn the handle
(7)
to the grass box.
3. Push the screw
(8)
through the hole inside the grass box.
4. Tighten the screw
(8)
.
4
GB
5041-20.960.02.indb 4
05.12.16 12:53
