16
TOLL FREE HELP LINE 1 855 691 5969
MODEL Y4007
MINI CULTIVATOR AND DETHATHER
ADJUSTING WHEELS
The wheels on the mini cul vator can be adjusted into two height po ons
(SEE FIGURE 11)
1.
To adjust the wheels, pull the detent pin out of the rear mounted plas parts mount hole
2.
Turn the rear mounted p
parts 180 degrees and then put the rear mounted p
parts into the rear hanging
board and then replace the detent pin
ADJUSTING
THE
DRAG STAKE
The Drag Stake is used to regulate the depth of cu v on and also to help maintain direc on and keep the mini
cul vator from leaping forward during op
on. Resistance to the forward mo on is achieved when the Drag Stake is
set to its lowest po on allowing deeper cul v on
(SEE FIGURE 12)
1.
Pull the pin out of the Drag Stake mount hole
2.
Posi on the Drag Stake so that the pointed end of the stake is directed downward
3.
Once desired depth is reached, reinsert the Drag Stake pin back into the hole
FIGURE 11
FIGURE 12
Always make sure engine is o
ff
whenever maintenance or cleaning is being done on the unit. Ma ke sure unit is
o
ff
when using tools and moving the unit from one loca on to the other by any means other than its own power
Never work on excessively steep slopes and always wear quality safety shoes when opera ng this device
Always inspect the area to be cul vated and make sure it is free of any o bjects that could be thrown by the unit
This device should only be operated by suitably trained adult individuals who have read the en re instruc ons
WARNING
High Position
Low Position
Detent Pin
Detent Pin
