Care And Maintenance
• Store the firebowl in a cool dry place away from direct sunlight.
• The propane cylinder must be disconnected and removed from the firebowl before the appliance can be stored indoors.
• Make sure both the gas and the firebowl are turned off before changing battery. Please refer to the process of installing the
battery.
• Use manufacturer approved or supplied replacement parts and accessories only. Otherwise it may void the warranty of this
product and result in a hazardous condition.
• Please contact the manufacturer for information regarding replacement hoses, thermocouples, ignitors, lava rocks, etc.
• Keep the firebowl free and clear from combustible materials.
• Visually inspect burner from obstructions. Keep fireplace free and clear from debris.
• After the burner and lava rocks are completely cooled down, use a soft brush to get rid of the mild stains, loose dirt and
soil. Wipe with a soft cloth.
Warranty
The manufacturer’s warranty will be voided by, and manufacturer disclaims any responsibility for, the following actions:
• Modification of the firebowl and/or components including the gas valve assembly.
• Use of any component part not manufactured or approved by manufacturer.
• Use and installation other than as instructed in this manual.
Operating Instructions
To Extinguish
1. Push and turn the control knob counterclockwise to the “OFF” position.
2. Turn the cylinder valve on the gas tank to close the gas supply if not in use for a long time.
To Light
1. Turn the cylinder valve on the gas tank counterclockwise to open the gas supply.
2. Close the storing door on the firebowl for the gas tank.
3. Press and hold the electric ignitor.
4. Push and turn the control knob counterclockwise to the “LOW” position.
5. Keep pushing the control knob to light the burner.
6. After ignition, release the electric ignitor.
7. Continue to push and hold the control knob for 45 seconds.
8. If ignition does NOT immediately take place in seconds, push and turn the control knob clockwise
to “OFF”. Wait 5 minutes, then repeat the lighting procedure as above.
Before each use, inspect hose. Replace hose if there are any signs of cutting, wear or abrasion.
9
