5
ASSEMBLY INSTRUCTIONS
Hardware Used
4
5-1
4. Attach post to cylinder housing using the reinforced
ring (NN), four M6 X 10 bolts (DD) and small flat washers
Φ6 (EE). Fasten them and cover with the deck ring (OO).
5. Table Installation.
5-1. Slide fastening nut (H) down the pole with the
rounded side faced downwards. Next, slide the
tightening spacer (G) down the pole with the smaller side
facing downwards. Put the table (F) on the pole with the
metallic side facing up.
5-2. Insert the screw coupler (E) on the pole, inserting it
through the middle of the table (F) on the pole. Thread
the tightening spacer (G) on the bottom of the table
counterclockwise onto the screw coupler (E). Tighten
securely to hold the table to the screw coupler(E).
Thread the fastening nut (H) counterclockwise. Tighten
securely to lock in place. Loosen the fastening nut (H)
to adjust the position of the table on the pole.
NN
EE
NN
Small flat washer Φ6
x 4
x 1
Reinforced ring
OO
x 1
Deck ring
oo
H
F
G
5-2
E
DD
Bolt M6 X 10
x 4
