4
ASSEMBLY INSTRUCTIONS
Hardware Used
AA
BB
Hardware Used
CC
1
2
3
TT
1. Attach wheel assembly (P) to base (O). Line up holes
in wheel bracket with corresponding holes in base, insert
two bolts
M8 x 16 (BB)
through holes, and finger tighten
two M8 flange nuts (AA)
. Be sure that the wheel assembly
is parallel to the base, and fully tighten bolts. To improve
the stability, bucket must be filled with sand.
2.
Attach cylinder housing (K) to base. Attach cylinder
housing loosely to base with four M5 X 8 screws (CC).
3. Attach post (L) to cylinder housing top. Open the door,
put post through the hole on the top of cylinder housing.
x 2
Bolt M8 x 16
M8 Flange nut
x 2
Screw M5 X 8
x 4
L
K
O
AA
CC
BB
P
Fill sand
