Gardebruk GB180SB, Manual

Page: 7 / 24

7 www. DEUBAXXL .de
COMMISSIONING
Note: Before operating the fountain for the first time, remove the protective film on the solar
panel.
1.
Select the desired nozzle attachment, B1-B6.
2. Plug the selected nozzle attachment onto the connecting tube B7 so that you get part F
(Figure 1).
3. Plug the nozzle F, B4, B5 or B6 onto the solar fountain.
It is possible to use the fountain with or without spacer.
If used without spacer, then installation step 4-5 is omitted.
4. Mount the spacer, inserting the connecting element D into the plastic pipe C. Repeat this
procedure for all four spacers (Fig. 2).
5. Insert the spacers H into the recesses provided in the solar fountain G (Fig. 3).
Note: Cut the plastic tubes to fit your water basin.
6. When placing the solar fountain in the water, make sure that the pump is completely covered
with water. Place the solar fountain in direct sunlight. The pump will not work properly if the
solar panel is shaded.
Instructions for using:
 Place the fountain in direct sunlight.

Make sure the solar panel gets enough sunlight and faces the sun. The water level depends
on the sun intensity, if the sunlight is weak, the pump will not be running continuously, but it
will turn on again automatically.
 When placing the pump, make sure that impurities cannot be sucked in. The pump must not
be placed in sand. The pump may be damaged if exposed to impurities.

Change the water regularly to keep it clean and to prevent dirt from getting into the pump.

Make sure there is enough water in the well, especially on sunny days. Always keep the pump
below the water surface.
Important. Do not allow the pump to run dry.
 Handle the solar panel carefully to avoid damage.

Always keep the surface of the solar panel clean.
MAINTENANCE AND CARE INSTRUCTIONS
Check all the parts for signs of wear. Do not continue to use the product if you find any defects.
Only have parts replaced with original spare parts by a specialist in accordance with the
manufacturer’s specifications. A lack of care and maintenance can damage the appliance.
Dangerous situations can arise. Regular maintenance helps to ensure the safety of the product
and increases its service life.
 Clean the pump once a month, use a pipe brush for this purpose.

If little or no water comes out of the well, remove the filter sponge for cleaning or
replacement.

Remove the nozzle.

Remove the water pump.
 Remove the filter sponge.
 Clean the filter sponge.

Reassemble the fountain.
Make sure that the water is kept clean, clean the pump regularly to prevent foreign objects from
settling in the pump and preventing it from sucking water.