Operation
1) Place the unit on a sturdy work surface.
2) Using the handle, lift and hold the cutting wire in the upright position.
3) Place cheese block on the cutting surface. Make sure the part of the cheese that is to be cut is on top of
the groove.
4) Gently pull handle so that tension is added to the cutting wire.
5) While maintaining tension on the cutting wire, slowly but firmly lower the handle and press the cutting
wire through the cheese block.
Cleaning and Maintenance
1) Remove the cutting wire.
2) Thoroughly clean the main frame and the cutting wire.
3) Dry all components and re-assemble the unit.
Replace Cutting Wire
1) Firmly grasp the handle with both hands and twist both sides in opposite directions to separate the two
halves. Unhook the cutting wire.
2) On the bottom of the unit, unhook the opposite end of the cutting wire. Remove the old cutting wire
from the unit.
3) Hook one end of the new cutting wire on the bottom of the unit.
4) Wrap the opposite end of the cutting wire around the pulley system. Make sure the wire is placed within
the groove of the pulley wheel.
5) Feed the end of the wire through the gap in the cutting surface and hook the other end of the cutting
wire to the screw located inside the handle.
6) Reconnect both halves of the handle by twisting in the opposite direction that you twisted in step 1.
Please read and comply with the instructions listed on this document. To get the best service life and
performance from your machine, clean it thoroughly before and after each use by following the instructions
listed below. Minimize the use of alkaline cleaners as they may dull the finish and cause pitting.
USER MANUAL
