GARANT 921401, Instruction Manual

Page: 51 / 532

en
1. Adjust the castors.
» The parking brakes must be within easy reach.
2. Keep the ▼ button depressed until the bottom stop is reached.
3. If the workbench has no battery:
» Disconnect the control module from the power supply and stow the cable securely in the
cupboard section.
4. Close the drawers and the door.
5. Release the parking brakes on both castors.
6. Move the workbench to the desired location.
7. If the workbench has no battery:
» Plug the control module into a mains socket.
5.4.1. Parking the workbench securely so it cannot roll away
(Fig.
L
)
WARNING
Unintentional rolling away
Risk of injury due to being run over by a workbench that was not secured.
» Do not use the workbench in areas where the floor slopes upwards or downwards.
» Before starting work, apply the parking brakes on the castors.
1. Lock both castors by applying the parking brake.
» Always secure the workbench before starting work.
5.5. BATTERY SETTINGS
Open the menu by pressing the OK button.
Use the ▲ and ▼ buttons to select the top of the menu, then confirm by pressing OK.
Use the ◀ button to revert to the previous menu.
i
The following items are displayed in every menu:
Power Power in Watts
Voltage Voltage in Volts
230 VAC Output Current operating data at the 230 V-AC output
Operation Status Display active (On / Off)
Current Current in Amperes
Energy Saver (no load) Energy-saving mode (no load)
1. Press the OK button.
2. Use the ▲ and ▼ buttons to set the desired time (between 1
minute and 10 hours). To deactivate this mode, press the ▼ but-
ton until “inactive” appears.
www.hoffmann-group.com 51