PixelPro GXi Series
ZN1-M3FN3 Installation Guide
03-2014-A
7
4. INSTALLATION
4.1. Installing the camera
Caution
!
To prevent products from damage, place the camera on stable and non-
vibrating surfaces If the stability is in doubt, consult safety personnel for
reinforcements, and then proceed with the installation.
1)
Place the installation template (outline
shown on the next page) included in the
package on the desired installation surface.
2)
Drill holes in correct positions based on
the template paper, and insert anchor
blocks into the holes.
3)
Make sure the necessary cables
including a LAN cable and a power cable
are properly connected to the camera
either thru the ceiling or thru the groove
around the mounting plate.
4)
Place the camera body and match the
alignment holes with the corresponding
anchor blocks and hold against the
mounting surface.
5)
Tighten the anchor blocks with screws.
6)
Adjust the angle of the camera. Refer to
“
4.2. Adjusting the angle of camera”
for
more details.
7)
Place the dome cover on the main body
of the camera. Dome cover has three
alignment holes that match camera body’s
alignment holes.
8)
Once properly placed, insert screws into
the three holes of the body and tighten
them up.