PixelMASTER GXi Series NVR
User’s Manual
05-2014-A
13
13
2.
GETTING STARTED
Controlling and setting NVR by remote control is limited to some of function, recommend you to use
mouse operation of NVR for using all the function.
2.1 CONNECT AND SWITCH ON
Please check if power of IP camera is turn on.
Connect one or more monitors to NVR using Digital Video output or VGA.
Connect power to NVR. Press the power button on the back panel of NVR to begin operation.
When you make system boot up, you can view following system loading process after boot up logo image.
[Logo Image]
Depending on Monitor which you connect to NVR, initial logo is not displayed because your
monitor is not support low resolution, so it is not a defect.
Initial set resolution is 1024 x 768, so you should use monitor higher than 1024x768
2.2 START SETUP
When you turn on at first time you can see the below menu.
SYSTEM LANGUAGE: Select the system language.
SYSTEM TIMEZONE: Select the system time-zone.
DATE FORMAT: Select the date format
VIDEO SIGNAL FORMAT: Select the video signal type
VIDEO OUTPUT RESOLUTION: Select the video output resolution.
Preview : You can check the preview of video resolution
The items which is defined in the 'START SETUP' would not be initialized after the factory default.
The settings in the 'START SETUP will replace the factory default value of each setting. After the
factory default in the setup menu, the items defined in 'START SETUP' will have the values
selected here.
