Once the cutouts are in place, slide the gobo holder ring all the way down un
ti
l it sits
fl
ush on top of the
wave spring. Tighten the set screws on the gobo holder ring so that the gobo holder ring can no longer
move along the op
tic
slider rails. Next, turn the gobo retainer half of a turn clockwise. This should hold
the Cinefoil or Blackwrap
fi
rmly in place.
The above image shows the Cinefoil cutouts installed into the wave spring
Now, trim away any material that may block the barrel from being put on.
From here, you can focus the beam as speci
fi
ed in the “Focal Adjustment” sec
ti
on of this document.
When focal adjustment is complete, screw the barrel back onto the
fi
xture.
