Q.uick Start Guide
Q.brixx
29
Gantner Instruments Inc.
USA | China | Singapore | India | Austria | Germany | France | Sweden
1550 Hotel Circle N ∙ Suite 180 ∙ San Diego CA ∙ 92108 ∙ T +1 888 ∙ 512 ∙ 5788
[email protected]
www.gantner-instruments.com
7.
Give the project a name.
8.
A blank project is now available.
Slave Setup
1.
When a new system is being used, the first step is to assign a unique address to
each measurement I/O module (skip this step if the address has been set using
the DIP switches, typical for most Q.brixx systems). There are two ways to
assign an address to a measurement module: via the DIP switches mentioned in
the previous assembly section or using test.commander. In this section, we will
discuss how to set the address using the software method.
2.
With a blank project open, select Utilities > Slave Setup Assistant:
