3/20
blade and the slab!
4. During machining process (especially the 45-degree chamfer), do not get too close to the saw
blade to prevent the danger of saw blade!
5. Every restarts, it needs to return all axis to zero and set the tool again!
6. The machine must be back all axis to 0.0 before operate table up & down!
7. Please don't forget to add hydraulic oil for the hydraulic pump!
8. The operator must not load and unload the blade until the saw blade completely stops rotating;
other people are strictly prohibited to operate the machine during the process of loading and
unloading the blade!
9. Operators must wear goggles, earplugs, masks and other basic safety protective gear!
10. It is strictly forbidden to open the control cabinet when it is working. If there is a fault, it must be
powered off for testing. The testing personnel need to have the corresponding professional
knowledge!
11. Before the machine is ready to cut, please check the status and various parameters to avoid
unnecessary errors (such as damaging the saw blade). Make sure that the parameters are correct
before cutting!
