Installation
G&D DVIMUX2-DL-USB ·
6
English
Setting up the device
1. Ensure that the computers, which are to be connected to the KVM switch, are
turned off. If the computers are provided with both keyboards and mouses,
unplug the cables of the input devices from the USB interfaces.
2. Place the KVM switch between the computers and the console. Please mind the
maximum cable length of five metres between the KVM switch and the computers
which are to be connected.
3. Before installing the KVM switch, decide which button on the front panel of the
device should be assigned to which computer.
Connecting the console devices
Keyb.:
Plug the connection cable of the USB keyboard in this interface.
Mouse:
Plug the connection cable of the USB mouse in this interface.
Line In:
If desired, connect a microphone or a headset to this interface.
Speaker:
Connect the speakers to this interface for output of audio signals at the
active computer.
Monitor 1:
Plug the monitor’s DVI-I cable to this interface.
ADVICE:
Connect the cables of the console and the computers preferably block by
block and from the bottom up. By doing so, you will avoid already connected
cables blocking your view of the interfaces.
Figure 2: Interfaces to connect the console devices
IMPORTANT:
You can also connect both input devices to the
USB2.0 Devices
interfaces
on the front panel of the device.
In this case, switching of the channels is not possible via keyboard!
NOTE:
If you purchased the multi-channel variant of the KVM switch, connect the
additional monitors to the
Monitor 2
interface.
Power
Monitor 1
Keyb./Mouse
Speaker
CON
Line In
Line In
USB 2.0
Line Out
CPU 1
DVI-I CPU 1
Line In
USB 2.0
Line Out
CPU 2
DVI-I CPU 2
Summary of Contents for DVIMUX2-DL-USB
Page 51: ...Deutsch...
Page 99: ...English...
