G&D DP1.2-VisionXG-Fiber Series, Installation And Operation Manual

Page: 92 / 156

Installation
11 · G&D DP1.2-VisionXG-Fiber
Transmission|Rx:
Insert the LC plug of another fibre optic cable. Connect the other
end of the cable to the Transmission|Tx interface of the user module.
Additional interfaces of expanded variants
RS232: Use the
RS232-M/F-2
cable to connect one of the computer’s 9-pin serial
interfaces to this interface.
Line In:
Use an Audio-M/M-2 cable to connect the computer’s Line-Out interface to
this interface.
Line Out:
Use the RS232-M/F-2 cable to connect the computer’s Line-In interface to
this interface.
USB 2.0 CPU:
Use the USB-AM/BM-2 cable to connect one of the computer’s USB
interfaces to this interface.
NOTE: Connect at least one of the computer module’s Transmission sockets (two
fibres) to the user module.
If the bandwidth of the cable connection(s) is
insufficient for the transmission of the
signals, image errors occur. In this case, connect other transmission sockets to the
user module.
IMPORTANT: The interfaces listed in this paragraph are only provided at certain
variants.
USB 2.0 CPU In Out
Line
RS232
PS/2 CPU USB CPU
Main Power Red. Power
Power
Red.
Main
PS/2 USB K/M Network A
Network B
Ready Ident.
System Fail
PS/2 CPU USB CPU