Appendix A: Default Controller Configuration
28
Level
2
Level
3
Level
4
Level
5
Level
6
Notes
GRN
Green display when Alarm is active
oN
Offset value for active High High / Low Low Mode
LtCH
No
Alarm does not latch
yES
Alarm latches until cleared via front panel
botH
Alarm latches, cleared via front panel or digital input
RMt
Alarm latches until cleared via digital input
CtCL
N.o.
Output activated with Alarm
N.C.
Output deactivated with Alarm
A.P.oN
yES
Alarm active at power on
No
Alarm inactive at power on
dE.oN
Delay turning off Alarm (sec), default = 1.0
dE.oF
Delay turning off Alarm (sec), default = 0.0
ALM.2
Alarm 2
oUt1
oUt1
is replaced by output type
Note:
This submenu is the same for all other outputs.
ModE
oFF
Output does nothing
PId
PID Control Mode
ACtN RVRS Reverse acting control (heating)
dRCt Direct acting control (cooling)
RV.DR Reverse/Direct acting control (heating/cooling)
PId.2
PID 2 Control Mode
ACtN RVRS Reverse acting control (heating)
dRCt Direct acting control (cooling)
RV.DR Reverse/Direct acting control (heating/cooling)
oN.oF
ACtN RVRS Off when > SP1, on when < SP1
dRCt Off when < SP1, on when > SP1
dEAd
Deadband value, default = 5
S.PNt
SP1
Either Setpoint can be used of on/off, default is SP1
SP2
Specifying SP2 allows two outputs to be set for heat/cool
ALM.1
Output is an Alarm using ALM.1 configuration
ALM.2
Output is an Alarm using ALM.2 configuration
RtRN
Rd1
Process value for oUt1
oUt1
Output value for Rd1
Rd2
Process value for oUt2
RE.oN
Activate during Ramp events
SE.oN
Activate during Soak events
SEN.E
Activate if any sensor error is detected
OPL.E
Activate if any output is open loop
CyCL
PWM pulse width in seconds
RNGE 0-10
Analog Output Range: 0
–
10 Volts
oUt2
Output value for Rd2
