Gamry Instruments Faraday Shield, Operator'S Manual, Page: 17 / 22

Chapter 3: Unpacking and Installation--Assembly
3 - 5
7. Mount ground connector, ring stand rod, and shelf
•
a 4 mm ground jack is provided which can be screwed into any open M4 thread on each side panel
inside the Faraday cage
•
screw ring stand rod in any of the four M6 threads at the bottom panel
•
the shelf can be mounted on flanges of side panels at two different heights
o
place shelf on flanges (upper or lower level) and attach with six thumb screws
o
slightly open thumb screws and slide shelf to remove it
8. Adjust cable entry plates for cables
•
all cable entry plates are pre-mounted; two are located at the top and three on each side panel
o
slightly unscrew thumb screws of cable entry plate and guide cable through the opening
o
tighten thumbs screws again to hold both cable entry plate and cables in position
thread for
ground connector
thread for
ring stand rod