Gamry Instruments Faraday Shield, Operator'S Manual, Page: 14 / 22

Chapter 3: Unpacking and Installation--Unpacking
3 - 2
Unpacking
When you receive your Faraday Shield, please verify that you have received the following items:
Table 1 - Faraday Shield - Rev 1 (992-00164)
Quantity Part number Description
1 730-00119 4 mm female banana socket, M4 male screw, insulated, black
1 810-00121 Faraday Shield - Bottom Panel
1 820-00161 Shelf, polypropylene
1 820-00163 Ring stand rod, 12 mm OD, 400 mm length, M6
14 835-00042 Thumb screw, plastic, M4 x 10 mm, black
4 850-00067 Rubber bumper, 1 5mm OD, 15 mm height, M4
1 966-00012 Door Panel Sub-assembly
3 966-00013 Side Panel Sub-assembly
1 966-00014 Top Panel Sub-assembly
1 988-00078 Operator's Manual
All panel sub-assemblies have their cable entry plates (P/N 810-00123) already pre-mounted.
Initial visual inspection
After you remove your Faraday Shield components from its shipping carton, check all parts for any signs of
shipping damage. If any damage is noted, please notify Gamry Instruments, Inc. and the shipping carrier
immediately. Save the shipping container for possible inspection by the carrier.
Assembly
Use flat and padded surface (e.g. carpet, cardboard, etc.) for assembling to avoid scratches. No tools are required
to assemble or disassemble the Faraday Shield.
1. Connect side panel sub-assemblies
•
each side panel has two pairs of quick-release hinges mounted
•
snap together corresponding hinges of all three side panel sub-assemblies (966-00013)