8
ASSEMBLY INSTRUCTIONS
String Reel Installation
The String Reel Holder pin is an 8 mm rod
with threads on both ends and fl at surfaces
machined on one end. Thread the end of the
pin without the fl at surfaces into the threaded
boss on the right side of the Lower Column.
Using the M6 open end wrench positioned
on the fl at surfaces, securely tighten the pin
to the Lower Column.
The String Reel Holder can hold up to 4 reels
of string (depending on the size of the string
reel). Before placing the fi rst reel on the rod,
slide two spacers over the pin and slide them
to the connector on the Lower Column.
After the fi rst reel is placed onto the rod, place two spacers between each reel to provide
enough space between reels to allow them to turn freely without rubbing against one another.
(To provide a smooth feed to the String Length Meter, place the reels on the rod so the string
spools off the reel from the underside of the reel).
After the last reel is installed, place the two M8 washers on the pin and attach the threaded
knob to the end of the rod.
