▪ F - MPCe/LPCe programmed calibration factor (typically set to 1)
▪ S - Configured pump size in l/s.
Units
The Units parameter changes the displayed unit of measurement for
pressure. It can be changed to display in Torr, m Bar, or Pascal. (Torr is the
default.)
Figure 6. Units
Setpoint
▪
On Point: The setpoint will deactivate when the pressure is equal to or
below this pressure.
▪
Off Point: The setpoint relay will activate when the pressure is equal to or
above this pressure.
▪
The off point pressure must be equal to or greater than the on point.
▪
When the off point value is set to 0.1e-10, the off point value will be
ignored, and once the setpoint is active, the setpoint will remain active
independent of the pressure thereafter.
▪
Error: The setpoint will turn on when the SPCe has an error condition.
Figure 7. Setpoint function config
Figure 8. Setpoint
04/2021 - ©Gamma
Page 18
900026_F
900026_F - Display menu
