28
Copyright © GamaBit Ltd. 2017 - 2020. All right reserved.
1.
The latest received value with a reporting date.
2.
Graphical overview of data statistics accumulated from the device.
4.3.11 Thermostat
1.
Last-measured internal temperature with reporting date - for thermostats that
support outside temperature measurement, additional information will be
displayed for the last-measured outside temperature with a reporting date.
2.
Calibration - the temperature measured by the thermostat often differs from the
room average, since the thermostat sensor is located in close proximity to the
heater. Therefore, it would be better to input this deviation so that all other
configurations are comparable to the average of the room.
3.
Heating - entering the desired heating temperature. The thermostats with an
occupation detector will be presented with two controls - one for temperature
configuration when the room is occupied and the other one when it is not. Also,
there are thermostats providing for cooling with/without an occupancy sensor -
they show controls analogous to the above.
4.
Current state.
5.
Heat on button.
6.
Heat off button.
7.
Emergency heat on button.
Different buttons may be shown/hidden depending on the type of the thermostat, such
as cooling, fan, etc. Turning on/off heating/cooling requires certain technological time,
and it is advisable that you wait a little before sending out another command.
4.3.12 Motorised Shades Configuration