Solar Lamp Location:
For optimum light duration throughout the night, it is very important to place the solar panel in a spot
where it will receive the maximum amount of direct sunlight throughout the day. Also, for best results
install your solar panel facing the south.
NOTE: The Light fixture is for OUTDOOR USE only and will not work properly indoor because
of the PIR sensor module.
DO NOT INSTALL THE LIGHT INDOOR!
Installation Instructions (Fig. 1)
1.
Install the solar panel using the 2 screws provided no more than 6ft from the light
fixture. Refer to the “solar lamp location” paragraph before choosing the installation
location.
2.
Use an electric drill to make two holes in the wall, place provided anchors into holes,
place the wall bracket in line with the holes and secure the solar panel with the
provided screws.
3.
Assemble the light fixture into the wall bracket using the provided screws.
4.
Connect the wire from the light fixture to the solar panel.
Operation Instructions
1.
Remove the round glass cover by turning it counterclockwise (Fig. 2)
2.
Turn the operation switch (Fig. 3) to the ON (|) position. Light will turn on automatically at
dusk and will be brighter when motion is detected. The Light
duration when Motion sensor is activated is about 45
Seconds and then returns to a normal mode.
3.
Reattach the round glass cover by turning it clockwise.
Fig. 1
Fig. 3
