PRE-INSTALLATION -
MOUNTING DETAILS
Main body
Hole centres must be at 215mm ±0.5mm
This is critical to ensure easy installation
Wall spuds must be ½” BSP MI and protrude
from the finished wall by no more than 15mm
Wall flange
Holes as per installation steps 4 & 5
INSTALLATION
IMPORTANT:
Galvin Specialised products must be installed in accordance with these installation instructions and
in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply
conditions must also comply to the applicable national and/or state standards. Failing to comply with these
provisions shall void the product warranty and may affect the performance of the product.
1. Fit wall flange
Apply thread tape/sealant to wall spuds to ensure
water tightness.
Remove tails from the
body and fit to wall flanges.
Ensure o-rings are secured in the rear of the flanges
then fit tails and flange assemblies to the wall spuds.
Tighten tails with supplied 12mm allen key until
flanges are secured against the wall. Take
care not
to overtighten.
2. Ezy-Wash
®
body
Check tails to ensure o-rings are fitted and
are in good condition.
Fit the Ezy-Wash
®
body onto the tails until it
sits flush against them. Take care not to
damage the o-rings.
Note: A male thread
connection on the tap may
be more suited. If so, please
contact us on 1300 514 074
