11
Version 1, 15 June 2020, 11 of 16
10.0
WARRANTY
The Galvin Engineering CliniMix
®
Thermostatic Mixing Valve is guaranteed free from manufacturing faults for a
period of 12 months, subject to the conditions and exclusions set out below;
GALVIN ENGINEERING PRODUCT WARRANTY
Galvin Engineering products are warranted to be free from defects in materials and/or workmanship for a period
of 12 months service life, and if found by Galvin Engineering to be so defective will be replaced as set out below.
If the product is sold by a party other than Galvin Engineering, then it is sold by the seller as principal and the
seller has no authority from Galvin Engineering to give any additional warranty on behalf of Galvin Engineering.
The benefits of this warranty are in addition to all other rights and remedies which the purchaser may have under
the Trade Practices Act or similar laws of each State and Territory in Australia.
Warranty Conditions and Exclusions
Conditions:
1. The Thermostatic Mixing Valve (TMV) must have been installed by a licensed plumber in accordance with
this document and in accordance with the National Plumbing and Drainage Code AS/NZS3500 (the Code)
current at the date of installation and all relevant statutory and local requirements in the State or Territory in
which the product is installed.
2. Where the product is installed outside the boundaries of a metropolitan area as defined by Galvin Engineering,
the cost of transport insurance and travelling shall be the purchaser’s responsibility.
3. Where the TMV comprises part of a hot water system, installation of that system must be in accordance with
its manufacturer’s recommendation, the ode and all relevant statutory and local tate or erritory
requirements.
4. The TMV must be returned to Galvin Engineering together with a fully and correctly completed Galvin
Engineering Warranty Claim Form.
5. Where the valve is replaced under warranty the replacement TMV carries a new warranty as detailed herein.
Exclusions:
Replacement work will be carried out as set out in the Galvin Engineering Warranty above, but the following
exclusions may cause the warranty to become void, and may incur a service charge including cost of parts where:
1. Damage has been caused by accident, Acts of God, misuse, incorrect installation, incorrect installation of the
water supply system of which the product forms a part of attempts to disassemble the TMV.
2. It is found that there is nothing wrong with the product
3. The failure of the TMV is due in part or in whole to faulty manufacture/installation of the hot water supply
system of which the product forms part.
4. The TMV has failed directly or indirectly as a result of excessive water pressure or temperature outside the
Application Guidelines, thermal input or corrosive environment.
5. The TMV has failed due to foreign matter either from installation or the water supply.
6. The failure of the TMV is due to scale formation in the waterways of the TMV.
7. The failure of the TMV is due in part, or in whole, to installation not in conformance with the requirements of
the Code.
8. Galvin Engineering reserves the right to change its specifications without prior notice and will not accept
liability for any claim arising from such change.
9. Subject to any statutory provisions to the contrary, claims for damage to furniture, carpets, walls, foundations
or any other consequential loss either directly or indirectly due to leakage from the TMV are also excluded
from warranty cover.
