© Copyright
Gallo Technologies
. All Right Reserved
- 5 -
52008
Lock/Unlock siren Chirp
: If this option is set to
DISABLE
the siren will not chirp when locking and unlocking the
doors.
Two Pulse Locking / unlocking
:
When pressing
or
the electrical pulse sent to the door
locking/unlocking mechanism can be set at either one pulse or two pulses. Most vehicles only require one pulse
(factory default). Some vehicles require one pulse to unlock the driver’s door only and a second pulse to unlock all
doors. If this is the case and you want all doors to be unlocked at the same time, set this option to two pulses. OR,
setting to one pulse will unlock the driver’s door on the first unlock button push then unlock all doors on the second
push.
*
Ignition Key Start Function:
If this option is set to
ENABLE
(factory default) the vehicle can be started by
using either the ignition key or the
ENGINE START
push button. If this option is set to
DISABLE
the vehicle can be
started with the
ENGINE START
push button only.
*
Disable Start Button Cut Off Delay
: If this option is set to
ENABLE
(factory default) the vehicle can be started
after the ignition key is turned
ON
and there will be no start button cut off delay.
*
30 Second Start Button Cut Off Delay:
If this option is set to
ENABLE
the vehicle can not be started 30
seconds after the ignition key is turned
ON
. Recycling the ignition key
OFF
to
ON
will reset the time delay for
another 30 seconds.
*
60 Second Start Button Cut Off Delay:
If this option is set to
ENABLE
the vehicle can not be started 60
seconds after the ignition key is turned
ON
. Recycling the ignition key
OFF
to
ON
will reset the time delay for
another 60 seconds.
*
5 Minutes Start Button Cut Off Delay:
If this option is set to
ENABLE
the vehicle can not be started 5 minutes
after the ignition key is turned
ON
. Recycling the ignition key
OFF
to
ON
will reset the time delay for another 5
minutes.
*
10 Minutes Start Button Cut off Delay:
If this option is set to
ENABLE
the vehicle can not be started 10
minutes after the ignition key is turned
ON
. Recycling the ignition key
OFF
to
ON
will reset the time delay for
another 10 minutes.
This section explains how to configure the
functions. See section 1.3 for detailed explanation
of each function.
1. The system must be in
DISARM
mode, and the Ignition key must be in the
OFF
position for a minimum
of 3 sec.
2. Cycle the Ignition key
OFF/ON
3 times, and keep the ignition key in the
ON
position the 3rd time. After 3
sec the parking lights will flash 2 times indicating the function setup mode has been activated.
3. Press the
ENGINE START
button
OFF/ON
“n” times and on the nth time hold the
ENGINE START
button in the
ON
position for 3 sec. The parking lights will flash either 3 times or 1 time indicating the
state that the function option has been changed to.
4. After turning the ignition key to the
OFF
position, the parking lights will flash 5 times, indicating the
Function Set up Mode has been exited.
5. To change another function option repeat steps 1 thru 4 above.
NOTE
: “n” indicates the number of times the
ENGINE START
button is to be pushed for the respective Function
Option in the first column of TABLE 1 below.
1.4 PROGRAMMING FUNCTION SET UP OPTIONS
