© Copyright
Gallo Technologies
. All Right Reserved
- 10 -
52008
Figure 6
Figure 7
7 Pin Wire Harness
(Parking Lights, Siren, Foot Brake and Door Trigger
Circuit)
Note: connect C3: Red, C3: Pink and C3: BLACK wires for stand alone “Engine Start” only configuration.
Connect all wires when installing “Engine Start with Alarm” configuration. See Fig. 8.
*
C3: RED fused wire
–
+ 12v Constant Battery Input (Module Supply Power)
. This connection should always
have +12v available (
BAT
terminal on ignition switch or equivalent). Solder connect the RED wire.
C3: YELLOW – Parking Light +12v output. 3Amps max.
Solder connect one of the YELLOW wires to the
vehicle’s parking light relay. If parking lights require more than 3 amps use an external 10 Amp relay.
C3: ORANGE – Siren +12v Output.
Connect to the RED Siren input wire. Connect the second siren input (BLACK
wire) to a good chassis ground.
*
C3: PINK – Ignition ON +12v Input for Active Arm Lock/unlock trigger.
Connect to
IGN 1
on ignition switch.
(+12v in
ON
and
START
position and 0 v in
OFF
and
ACC
position.)
C3: BLACK/WHITE – Neg. (-) Door Trigger switch Input.
Connect the BLACK/WHITE wire to the Neg. (-) Door
Trigger switch. If vehicle has “+” Pos Door Trigger input use an external relay as shown in Fig. 8.
C3: GRAY/RED - +12v Foot Brake Switch Input Used for Active Arm door lock input.
Connect to Foot brake
switch terminal that has +12v only when foot brake is depressed.
*
C3: BLACK – Neg. (-) Ground Connection
Connect the BLACK wire to a good chassis ground in a convenient location.
Installing Connector C3:
