ENG - 20
• Do not do the following: pull or carry by the cord, use cord as a handle, close a door on cord or
pull cord around sharp edges or corners. Do not operate appliance over cord. Keep cord away
from heated surface.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not place this appliance or cord on or near a heat surface.
• Do not handle plug or appliance with wet hands.
• wARNING:
Appliance not far continuous use. Approved for one operating cycle per two minutes.
• The appliance has a hot surface. Persons insensitive to heat must be careful when using the
appliance.
DESCRIPTION Of THE CONTROLS
P1
LID
P2 ROLL COMPARTMENT
P3
SEALING WIRE
P4
VACUUM NOZZLE
P5
SEAL INDICATOR LIGHT (GREEN )
P6
VACUUM INDICATOR LIGHT (RED)
OPERATING yOUR VACUUM SEALER
TO MAKE A BAG
1) Place the unit on a firm ,level surface near an electrical outlet.
2) Insert the roll of bagging material in the roll compartment in the sealer. We recommend you
use only the plastic material supplied by seller.
3) Plug into an AC electrical outlet.
4) When starting a new roll, remove the sticker from the outside of the roll. Pull the bagging
material to the desired bag past the sealing wire.
NOTE:
The roll is folded into a double layer.
5) Close the lid and press down evenly all lid. Both Indicator lights will light up. In about 6
seconds the green ‘Seal’ indicator light will go out and the seal is complete.
NOTE:
When closing the lid and applying pressure, two distinct clicks will be heard. These
are the switches which operate the two functions of the bag sealer.
