Page 9
3E4290 Gallagher T12 Reader | Edition 1 | August 2016
Copyright © Gallagher Group Limited
Cardax IV Reader connection:
Positive
Red
Negative
Black
HBUS Termination Orange
HBUS A
Green
HBUS B
Brown
CDXIV TX
White
CDXIV RX
Blue
Car
da
x IV R
eader
5.
Fit the facia assembly into the bezel by clipping the small lip, into the top of the bezel and holding
the top, press the bottom of the facia assembly down into the bezel.
6.
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security screwdriver) through the
hole at the bottom of the bezel to secure the facia assembly.
Note:
The Torx Post Security screw needs only to be lightly tightened.
Bezel
Fit screw to secure facia to bezel
Connection
Reader tail
Building cable
Facia
7.
Removal of the facia assembly is a simple reversal of these steps.
8.
Configure the reader in Command Centre. If the reader is connected as an HBUS Reader, refer to
the topic
"Configuring HBUS Devices"
in the Command Centre Configuration Client Online Help.
If the reader is connected as a Cardax IV Reader, refer to the topic
"Creating Readers"
in the
Command Centre Configuration Client Online Help.
