How to select the set point
1. Push and immediately release the key, the set point will be shown.
2. Push and immediately release the key, or wait about 5s to return to normal
visualization.
How to change the set point
1. Push the key for more than 2 seconds to change the Set point value.
2. The value of the set point will be displayed and the
°C
or
°F
LED starts blinking.
3. To change the set value push the or button within 10s.
4. To memorize the new set point value push the key again or wait 10s.
How to start a manual defrost
1. Push the key for more than 2 seconds and a manual defrost will start
In programming mode it browses the parameter codes or increase the display
value
In programming mode it browses the parameter codes or decrease the display
value
To lock or unlock the keypad
To enter in programming mode
To return to room temperature display
8
LED
Mode
Meaning
on
Compressor enabled
flashing
Anti short cycle delay enabled (AC parameter)
on
Defrost in progress
flashing
Dripping in progress
on
Measurement unit
flashing
Programming mode
on
Measurement unit
flashing
Programming mode
