LEFT
RIGHT
LEFT
RIGHT
POWER
LEVEL
MIN
MAX
FREQUENCY
50Hz
150Hz
LINE IN
L
R
HIGH LEVEL OUT
HIGH LEVEL IN
Power Rating: 220-240V AC 50Hz
Max Power Consumption: 100W
www.gale.co.uk
CAUTION:
AVIS:
ACHTUNG:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
VORM ÖFFNEN DES GERÄTES
NETZSTECKER ZIEHEN
REPLACE WITH FUSE
TO BS4265/IEC127
T0.8A L 250V
0
180
0
180
PHASE
+
+
-
-
3070 SUBWOOFER
ON
AUTO
POWER
ON
OFF
1. Level
This control allows you to adjust the volume of low frequency output
from your subwoofer amplifier to obtain the best sound-balance within
your surroundings
2. Frequency
This is used to adjust the point at which the crossover will separate the
low frequencies being used by the subwoofer from the higher
frequencies played by the rest of the system. Raising the Low
Frequency Cut-Off will increase the frequency range that the 3070 will
reproduce. Lowering the Low Frequency Cut-Off will limit the range of
frequencies reproduced.
3. Phase
This allows you to optimise the phase of your 3070 to different listening
positions and that of other speaker systems used at the same time.
4. Power Auto/On
If switched to auto, the subwoofer will remain in standby mode until a
signal is detected at the input. The unit will then automatically switch
itself on. It will then automatically return to standby mode if no input
signal is present for approximately 5 minutes. With the switch in the
'ON' position the unit remains permanently on as long as the main
power switch is on. The LED positioned on the rear panel indicates
whether the unit is on or in standby mode (red for standby and green
when on).
5. Line Input
If your amplification system has a dedicated subwoofer line output it
should be connected here (see fig.1 opposite).
6. Power Switch
Turns the subwoofer on and off
Subwoofer Controls
6
2
3
4
5
1
AP12401/4 Gale 3070 Owners' Manual (page six)
6
7
Print Pantone Black
for Koda
