For safety reasons please read the following instructions and the enclosed
Important Safety Information carefully before attempting to connect your
subwoofer unit to the mains.
Use of controls or adjustments or performance of procedures other than
those specified may result in hazardous radiation exposure.
The lightning flash with the arrowhead symbol within an
equilateral triangle is intended to alert the user to the presence
of uninsulated ‘dangerous voltage’ within the product’s
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intend
ed to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature
accompanying the appliance.
This product complies with European Low
Voltage (73/23/EEC) and Electromagnetic Compatibility
(89/336/EEC) Directives when used according to this
instruction manual.
Warning
To reduce the risk of fire or electric shock, do not expose this appliance to
rain or moisture.
Caution
Caution
To reduce the risk of electric shock, do not remove cover (or back). There
are no user-serviceable parts inside. Please refer all servicing to a qualified
engineer.
Plug Fitting Instructions (UK only)
The cord supplied with this appliance is factory fitted with a 13A mains plug
fitted with a 3A fuse inside. If it is necessary to change the fuse, it is
important that a 3A one is used. If the plug needs to be changed because it
is not suitable for your socket, or becomes damaged, it should be cut off and
an appropriate plug fitted following the wiring instructions below. The plug
must then be disposed of safely, as insertion into a 13A socket is likely to
cause an electrical hazard. Should it be necessary to fit a 3-pin BS mains
plug to the power cord the wires should be fitted
as shown in this diagram. The colours of the
wires in the mains lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug. Connect
them as follows:-
•
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter ‘N’ or coloured BLACK.
•
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter ‘L’ or coloured RED
•
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is marked with the letter ‘E’
or
coloured GREEN.
Note
If a 13 Amp (BS 1363) type of plug is used a 3 Amp or 5 Amp fuse must be
fitted, either in the plug or adaptor, or on the distribution board
.
E
GREEN /
YELLOW
BLUE
FUSE
BROWN
CORD
GRIP
N
L
Important Safety Precautions
3
AP12401/4 Gale 3070 Owners' Manual (page three)
Print Pantone Black
for Koda
