4. Irrigation Programming
1
. Open the top cover.
2
. Set the irrigation time selector to the desired irrigation duration.
3
. Set the irrigation cycle time selector to the desired cycle time.
4
. Press the "START" switch.
The tap will open immediately and the irrigation will commence, for
the set duration and cycle times.
For example:
• If you set the irrigation cycle time selector to "1 Day" and the
irrigation time selector to "30 MIN". The tap will open immediately
upon pressing the "START” switch and will remain open for 30
minutes. The tap will open at the same time on the following day
for 30 minutes everyday.
The tap will open every day at the time you pressed the switch on
the first day.
Please note: You can change the irrigation duration and the cycle
time even after you activate the program by changing the settings
of the selectors.
5. Programming an Irrigation
Controller with a Delayed
Opening Time
For Example, a 3 Hr irrigation, once every 3 days program,
programmed to start 6 Hr later.
1
. Set the irrigation time selector to 3 Hr.
2
. Set the irrigation cycle time selector to "Delay".
3
. Press and hold the "START* switch until you hear G clicks,
including the first click, (the number of clicks corresponds to the
number of delay hours before the controller opens the tap for the
first time).
4
. Set the irrigation cycle time selector to "3 Days".
When you set an odd number of delay hours you will hear an
additional click a few seconds after releasing the switch. This click
keeps the tap closed until its first opening.
*To change the opening hour, remove the batteries for 3 minute.
Program the controller from the start after replacing the batteries.
6. Maintenance
Remove the battery if the irrigation controller will not be used for a
prolonged time. Remove the filter and clean it periodically (every
few months). Failure to clean the filter may cause problems.
Estimated life span of the battery is one year at least.
