Questions?
www.galbreathproducts.com
1-800-285-0666
9
LOADING PROCEDURE
These instructions are intended to promote efficient
and proper operation. They do not cover every
possible situation that can occur when operating the
equipment.
1. Align the hoist rails with the long sills on the
container and back the truck as squarely as
possible to the container. Allow 3 - 4 feet between
the container and hoist (allow 8 - 9 feet for
extendable tail models). Put the transmission in
neutral and engage the PTO. Fully extend the tail
on extendable tail models.
2. Raise the hoist until the tail touches the ground.
(NOTE: Do not allow the hoist tail to lift the truck
up by raising the hoist after the tail is touching
the ground.)
3. Set truck brakes. Retract the winch cylinder and
connect the cable to the container hook.
4. Release truck brakes. Pull the container onto the
hoist allowing the truck to roll under the container.
Before operating the equipment:
1. Be sure the area is clear.
2. Check the area for low power lines or any other
obstacle which may interfere with hoist operation.
3. Never operate equipment which is damaged and/or
improperly maintained.
4.
Always operate the equipment within its rated
capacity.
5.
Study this entire manual and become properly
trained with this equipment before attempting to
operate it.
Failure to follow the procedures listed above may result
in severe injury or death and/or damage to equipment.
WARNING
Check to be sure the cable connection is securely
attached and in good condition.
A cable breaking or releasing under tension could
result in severe injury or death to the operator and/or
bystanders.
WARNING
