3
G8-09-11-2018
Remote Functions and Programming
Your remote and gel pad can be programmed for either Momentary or
Latching Modes.
Momentary:
You must hold the button down for the
lift to move.
Latching:
Press and release the button and the lift
will travel until you stop it, or it reaches its limit.
*** For marine and other applications where limits
are not used, the controller must be used only in
momentary mode. It is unsafe to operate these
units in latching mode; it is also against NEC code!
***
Momentary
You MUST move quickly during this process!
Please read through instructions thoroughly before starting. The control
board will exit the programming mode after 7 seconds of inactivity; you
may have to practice the steps a few times before programming your
remote successfully.
1.
Have all remotes present.
2.
Press and hold the learn button on the gel pad until the green
LED beside the button lights up (approximately 3 seconds).
3.
Press either the up or down button on your remote; you will see
a corresponding flash from the learn LED.
o
Additional Remotes:
Repeat this step with each remote.
4.
Give the learn mode about 10 seconds to expire, you will see a
rapid flash from the learn LED.
5.
Now test the remote(s) to see if the programming was successful!
