3. Tear off the back protective paper of the
then the sides of adhesive tape as FIG.4 - and stick it on
the window, Tear three right sides protective paper about 10mm, and fix the window in the
as
4. Tear off the adhesive protective paper of the lining and stick it on the door as FIG.4 - slip the hook on the
doorframe, and fix the doorframe on the door, tighten it with
- screws.
assembled, check
the hook working in normal and whether the hinge (UP) is its position.
5. According to the FIG. 4
pastę the inner lining inside the
it is pasted
smoothly, and should have no air
6. Slip the washer in the hinge
then
the hinge
in the hinge hole on the bottom of the oven, the
hinge in the rectangle hole on the
above, and hooked it with the door hook.
7. Place a
thin paper between the door and the oven, level the door and the oven, then push the door
to the oven, and tighten the
screws of the hinge (UP) and paint them.
4.3 THE
PANEL AND THE
out the power
Take off the cabinet.
Discharge between one end of the capacitor and the baseboard with a
screwdriver.
To
out the terminal
of the time and power distributor.
2. Take off the screw which fix the control panel with a
- screwdriver
(FIG.4 - 6)
3. Take off the control panel.
To assemble,
(1) Place the two buckles under the control panel into the two rectangle
under the oven as FIG.4 - 6, then
close of the control panel and
the oven with being fixed with a screw.
in the terminal
4.4 THE
Firstly, do as
steps at III of this
To
Take off the screw beside the oven lamp (FIG.4 - 8).
2. Take out the four screws which fixed the magnetron, and take the magnetron off (FIG.4 - 7).
magnetron
magnetron holder magnetron holder
lamp shade
Fig. 4-7
To assemble the magnetron,
1. Check whether the copper filament weaved washer of the magnetron antenna has been placed
It
should not be fixed if there is no copper filament weaved washer, for it
cause the magnetron and the
oven can't
well, and cause
amount of microwave leakage. Attention : When a new oven matches
11
