GALA Sensitive Smart, Installation Instructions And User Manual

Page: 36 / 60

The auto-cleaning cycle
does not initiate
Remote control does not
activate
The maintenance heater
of the water temperature
does not maintain the
temperature
Lack of disinfectant liquid
(see informative screen)
Discharged batteries
Discharged batteries
Remote control is not
synchronized with the bathtub
Safety thermostat
discharged
Wrong selection of
a function
Refill the correspondent tank
with disinfectant liquid
Switch batteries
Switch batteries
Synchronize remote
Press the function selection key
for more than 3 seconds
No function is activated
Remote control retro illumination
does not turn on
Bathtub does not respond
to the remote control’s
orders
ANOMALY POSSIBLE CAUSE
SOLUTION
The differential switch or the
thermo magnetic relay was
triggered
Put the switches in the position
of closed circuit (ON)
If it triggers again, do not turn it
on again; contact your distributor
Water level too low
Fill above the uppermost jet
Motor damaged or obstructed Contact your distributor
Contact your distributor
Contact your distributor
Energy failure
Misregulated level sensor
Make sure there is power in the
house
ANOMALIES DETECTION
If you have any anomaly in the bathtub, do
not allow anyone to intervene in its interior,
except the technical assistance service. Verify
the following anomalies table, and if
necessary contact a GALA distributer.
34
hard
neutral
soft
MAINTENANCE AND CLEANING
Put the empty packaging containing this
product in a recycling bin, by correctly
separating the diverse materials.
When the product is of no use anymore, do
not throw it away nor put it in the city
domestic garbage bins. Send it to the
authorized entities.
If you need any further information on the
entity to deliver it to, contact the local
services.
Most of the materials used to produce this
product are recyclable, so they may be part of
other new products or be used as raw
materials. It's up to you.
ELIMINATION OF ELECTRIC AND
ELECTRONIC WASTE
At the end of its life cycle, the product must
be eliminated accordingly to the present
recycling regulation and it must not be
managed as usual urban waste.
The product ought to be eliminated in a
specialized recycling plant or returned to the
retailer in case it is replaced by an equivalent
product.
Symbol: it shows that the product complies
with the new policy requirements on
environmental protection (2002/95/CE.
2002/96/CE, 2003/108/CE) and it must be
correctly eliminated at the end of its life cycle.
Contact the legal authorities to obtain
information on the local of waste
management. The disrespect for the
requirements concerning the product
elimination indicated in this paragraph is
punished by law.
35
WASTE MANAGEMENT