GALA Sensitive Smart, Installation Instructions And User Manual

Page: 35 / 60

HEATER TO KEEP THE WATER
TEMPERATURE
• The icon turns on the heater. If you
press this key again you will stop this
function.
The WATER hydromassage must be
activated for this function to work.
• The heater will maintain the water
temperature (more or less 1ºC) registered in
the moment of activation.
LED RGB
• By pressing the icon, the light will be
turned on and the automatic colours
sequence will start, with each colour lasting
for about 15 seconds (see colours / effects
table on page 48)
• With a second pressing of the icon,
the light will shut down.
• To choose a specific colour, wait till it comes
in the automatic sequence and touch it twice,
or consecutively press twice till the desired
colour is selected.
•Touch it a last time to turn the light off.
RESTORE FACTORY PROGRAMS
On the main menu select the icon .
Check if the 4 memories are activated. (full
black triangle).
32
If any of the triangles is empty, activate the
memory.
Return to the main menu by selecting the
icon.
In the main menu select the icon and
then press the icon for 3 seconds.
25ºC 15'
25ºC 15'
25ºC 15'
25ºC 15'
PRESS
3 Sec .
AAA
1 2 3 4 5
ON
OFF
15 Sec .
Off
On
Off
On
OK
ERROR
REMOTE CONTROL SYNCHRONIZATION
TURN OFF AUTOMATICALLY
So as to make the equipments life cycle
longer, this remote control has a “turn off
automatically” system. If you are 20 seconds
without touching the remote control screen or
without activating a function, the device will
turn off itself automatically.
FINAL BLOW
The bathtubs equipped with AIR
hydromassage activate the “final blow”, which
cleans the correspondent conducts. This blow
is only carried through when the bathtub is
empty and the remote control is deactivated,
in the next half an hour after the
hydromassage use or the disinfection action.
WARNING SIGNAL OF MINIMUM WATER
LEVEL
When filling the bathtub, when the water
level exceeds the highest injector, bathtub
emits an audible signal, indicating that the
water level is enough for the hydromassage
system to work.
WARNING SIGNAL OF WATER
TEMPERATURE
When the water temperature in the bathtub is
superior to 50ºC, the bathtub will make a
sonorous signal and it will appear a danger
sign next to the temperature. All bathtub
functions will be blocked until the
temperature decreases to 40ºC.
LOW BATTERY SIGNAL
When initiating the remote control if the
symbol shown above appears it means that
the battery is low and it must be replaced.
The remote control will continue functioning
but the retro illumination will be turned off in
order to spare the batteries.
BATTERIES CHANGE
If the low battery sign appears in the screen
replace the batteries of your remote control.
The batteries to be used are two AAA
batteries, and you should proceed this way:
• untwist the screws and remove the back
cover of the remote control.
• remove the two AAA batteries and place
new ones, in the position indicated in the
picture above.
• make sure that the sealant is well placed,
because this will guarantee the remote
control estanquicity.
• put the cover back in its place and screw it
back.
• touch the screen to initiate its use.
• if at the end of 15 seconds the temperature
is kept in 0ºC, you must initiate the
synchronization process..
33
AAA