Task 3
13
14
15
• Insert key and turn clockwise.
• Remove the mounting plate.
• The key can now be turned back to the vertical position
and removed.
• The
rotor
is pre-installed onto the mounting plate. The rotor
must be positioned such that one notch faces upwards, and
the other notch faces towards to latch side (door opening).
•
Mount and hold the outside faceplate
onto the outside
door face. Assemble the mounting plate to the outside face
plate. Make sure the connector wires pass through the large
rectangular hole in the mounting plate and that the spindle
engages the outside lever.
• Fit 2 mounting screws from
KIT B
and tighten.
•
Insert key
into the inside faceplate and
turn clockwise.
Leave key in this position.
• Assemble the
connector
from the
Battery Box
with the
connector
on the
faceplate
. Make sure they are firmly
pressed together.
• Hold the
faceplate flush against the door face
making sure
that wires from the Battery Box are not trapped. The key can
now be turned back to the vertical position and removed.
The faceplate is now temporarily secured and will not fall
if let go.
• Fit 4 mounting screws from
KIT C
and tighten.
Inside
door face
Turn key clockwise
Turn key clockwise
NOTE: If “KIT B” contains 2 length of screws then use the
following guide:
• For doors up to 40mm thick use the 2 “short” screws.
• For doors 40mm and over use the 2 “long” screws.
NOTE: Do not let go of the faceplate or allow the faceplate
to “hang” from the wires.
NOTE: The mounting plate must first be removed from the
inside faceplate.
Make sure the
connectors are
pushed together
Rotor
