HINTS ON THE USE OF YOUR APPLIANCE
For the deep cleaning of your home, we recommend cleaning with steam at least once a week.
Very dirty floors:
Begin first with the steam cleaning (use the large multifunction brush (b) with the rubber lip attachment!
(c)). For the cleaning of very dirty floors, first switch on the steam to loosen the dirt. Then stop the
steam and vacuum the floor
Normally Dirty Floors:
With normally dirty floors, work simultaneously with the steam and vacuum functions (use the large
multipurpose brush (b) with the rubber lip attachment (c)) To do so, switch on the steam and vacuum
functions.
Move the vacuum hose constantly in one direction (either toward the body or away from the body).
After finishing the cleaning work, switch off the steam at the on/off button (f) but leave the vacuum
function switched on (g) for another moment so that the remaining dirty water can be transported
into the dirty water tank.
Please Note:
If the steam function is to be used on flooring that requires a cleaning product, such as marble or
PVC, we recommend the use of a terry cloth towel over the floor tool. Adjust the steam volume to
the surface which is to be treated (steam level – button 13).
Rugs and Carpeted Floors:
The machine can deeply clean dust away from all types of rugs and carpeted floors. To do so, use
the large multipurpose brush (b) with the stiff attachment (d)
First switch on the vacuum function and vacuum your rug or carpeted floor as usual to remove the
dust. Then switch on the steam and vacuum functions in order to carry out a deep cleaning. This
type of cleaning brightens up the colour and gives your carpet back its original volume. Impurities
are removed from the very roots of the fibres.
In the case of encrusted areas or special stains, we recommend
treating these first with the nozzle with curved end (j). To do so,
set the steam level (button 12) and vacuuming power (button 13)
to the maximum.
Note:
The attachments for rugs and carpeted floors can be applied
to the bristled frame (d) by introducing them from the side into the
corresponding slides. Fig. 14.
Windows
Work simultaneously with the steam and vacuum functions (window wiper (j+h) for window
surfaces/mirrors/wall tiles.
Switch on the steam and vacuum functions. In order to be able to achieve the best possible cleaning
results, always work from top to bottom.
With very dirty windows, you should clean these first only with the steam function (without the vacuum
function) and then only with the vacuum function (without the steam function).
Begin the cleaning while you have placed the special tool with the rubber lips directly against the
glass surface. Then guide the rubber lips slowly downward. When the vacuum function is switched
on, the steam and the condensed water will be vacuumed up again.
Please note:
In the winter, the glass surfaces should be pre-warmed from a distance of 5 to 10 cm. (2 to 4 in.)
27
Fig. 14
Summary of Contents for 8000
Page 1: ......
